Mohammad Beidaghdar; Ebrahim Fataei; Behnam Khanizadeh; Ali Akbar Imani
Abstract
Pollution from industrial effluents is more diverse and complex than municipal wastewater due to the use of thousands of new chemical compounds in industry every year. Subsequent introduction of small quantities of these compounds into water streams through industrial effluents has complicated water ...
Read More
Pollution from industrial effluents is more diverse and complex than municipal wastewater due to the use of thousands of new chemical compounds in industry every year. Subsequent introduction of small quantities of these compounds into water streams through industrial effluents has complicated water pollution problems and posed many challenges in removing contaminants from water. The purpose of the present study was to remove phenol contaminants from the effluent of petrochemical wastewater treatment plants using advanced photochemical oxidation method (ultraviolet/hydrogen peroxide/ozone) in a laboratory scale. The experiments were performed using UVC light, 30 % H2O2 as oxidizer and phenol (100 mg/L). The effective parameters studied in phenol removal included pH, H2O2concentration, solution temperature and UVC irradiation time. The experimental results showed an increase in phenol removal efficiency with increasing H2O2 concentration up to 400 mg/L while decreasing with increasing oxidizerconcentration to 500 mg/L, thus suggesting a concentration of 400 mg/L as the optimal value. Using a flow rate of 200 mg/L of ozone for 80 min, by optimizing other conditions, increased the phenol removal efficiency by 98 %. The phenol removal efficiency was much higher at acidic conditions than at alkaline and neutral ones. The phenol content decreased significantly with increasing contact time. In other words, prolonged contact time increased the phenol removal efficiency in the tested sample. The highest phenol removal efficiency (75.7 %) occurred at the pH value of 4 and the phenol removal efficiency in the sample decreased with increasing pH value. Prolonged contact time caused more phenol concentration to be removed from the test sample, so that 69.8 % of the phenol concentration in the sample was reduced. The results of this study showed that advanced oxidation reduced the phenol content in the analyzed sample. To conclude, the advanced oxidation methods can be useful in the process of treating petrochemical wastewater andeffluent of units containing toxic aromatic compounds such as phenol.
